Trouble shoot table

tubular motor cannot run or start too slowly or with big noise.

1. incorrect line onnection;
2. wrong installation;
3. the voltage is too low.

1.check the lines;
2.correct the installation,
3. check the load.

tubular motor stop running when working. 1.reach the max limit switch;
2. working time lasts too long.

1.adjust the limit switch according to illustration;
2. restart after cooling the tubular motor 40 minutes

The set limit switch cannot satisfy the requirements. The set limit switch is not suitable to the custom’s requirements. Adjust the limit switch according to illustration.
      Copyright 2004-2005 Huate Limited All Rights Reserved